crosluv.blogg.se

Weboost antenna on truck
Weboost antenna on truck









The Minimum Required Separation Distance is mainly observed between the two antennas, as it is critical to your booster's continued operation. The signal booster unit itself does not require minimum separation distance from the outside antenna but does need a 18 inch to 24 inch separation from the inside antenna. If the booster is working, no adjustments need to be made. If the booster displays a flashing red and green light, the booster is indicating that oscillation is being detected, but it is most likely still performing at a satisfactory level. If this occurs, increase the straight-line distance between the two antennas. Typically, a solid red light displayed on a weBoost signal booster indicates that oscillation has been detected and the booster is shutting down completely as a result. When this happens the booster will begin to reduce its gain to prevent damage to the mobile network, and will not resume optimum operation until the separation distance issue is corrected. Oscillation occurs when the antennas pick up each others signals and create a feedback loop. If antennas are placed too close together, the booster may experience oscillation. The weBoost Drive 4G-X OTR uses weBoost’s most powerful in-vehicle signal booster kit, the Drive 4G-X, alongside weBoost’s new 304414 4G Trucker Antenna, to make the most powerful large truck booster available.Drivers stay in contact for longer with fewer lost connections and dead zones, better audio quality, and faster data uploads and downloads. The metal roof of your vehicle acts as a shield between the two antennas, making antenna placement a bit less critical for vehicle boosters. The Top Signal MagMAX magnet mount firmly secures. Wilson’s modular OTR antenna gives you a choice of mast heights from 10 to 41.

weboost antenna on truck

With its increased uplink power, the Drive Reach can send signal to towers that are twice as distant as older vehicle boosters. Separation is NOT measured by the length of cables that connect the two antennas to the booster.įor a vehicle booster installation, it is best to place the outside antenna towards the rear of the roof on the passenger side. Features of the weBoost Drive Reach OTR for Service Vehicles & Pickup Trucks. PLEASE NOTE: Separation is measured as a straight line between the two antennas.

weboost antenna on truck

If those distances are not feasible for your application, it can be achieved by doing a combination of the two (E.g, 10 feet vertical AND 30 feet horizontal). To find the MRSD for your specific booster model, refer to the Installation Guide that came with your booster.Īs a general rule, the inside antenna and the outside antennas need 20 feet vertical OR 50 feet horizontal separation. Each weBoost signal booster has a specific Minimum Required Separation Distance between the tower antenna and the device antenna that MUST BE STRICTLY OBSERVED.











Weboost antenna on truck